Trouble with using two gate nodes

When using two gate nodes one of the the output will always run but the other wont even when it should. The image below shows this as the blue line runs all the time but the red doesn’t.

and with that ?

Tried that just now and it only ran the branch which had the value box ticked on the Boolean node. Really confused at the moment, all i want it to do is if its a 1 change to a 0 and if its a 0 change to a one. I dont know why its only running one of them

It’s strange. If I test the following, I see the alternance T or F when I click mouse right.

Did you test Armory examples and found others strangeness ? :slight_smile: